Source removal, coil cleaning, and dryer vent service in one visit

Furnace and Duct Cleaning Pleasant Grove UT for cleaner air and lower bills

Furnace and Duct Cleaning Pleasant Grove UT pulls the dust, pet dander, and debris out of your supply and return runs instead of just blowing it around. We serve homeowners and small commercial buildings across Utah County, from Old Town to Grove Creek. If your registers are streaked black or your furnace smells musty when it kicks on, book a same-day inspection and get a straight answer on what your ductwork actually needs.

↗
Fast online booking

Request service today

Tell us what is happening. Our local team will confirm your visit shortly.

No spam. No obligation. Just practical help.
Thanks — we'll call shortly to confirm your visit.
Experienced Air duct Cleaning professionals at work
Careful work. Honest options.
About this service

What Furnace and Duct Cleaning Pleasant Grove UT actually involves

Furnace and Duct Cleaning Pleasant Grove UT is the mechanical removal of accumulated dust, debris, and biological growth from every connected component of your HVAC system - supply trunks, branch runs, return ducts, registers, the blower compartment, and the evaporator coil. We run a rotary brush duct cleaning machine through each run while a negative air machine and HEPA vacuum hold the system under negative pressure, so dislodged debris travels to the collection unit instead of into your living room. A duct camera inspection system confirms what came out and what is left behind.

Most Pleasant Grove homes we open up were built between the 1970s and the 2000s, and the original duct board and flexible duct insulation has had decades to collect dust, rodent debris, and construction fallout. Add Utah County's spring pollen load and winter inversion dust, and a system that has never been cleaned is moving contaminated air every time the blower runs. If you have been searching for Furnace and Duct Cleaning Pleasant Grove UT near me because allergies or musty odors got worse this fall, the ductwork is usually the first place to look.

  • ✓ Less dust on every surface
  • ✓ Relief for allergy symptoms
  • ✓ Lower heating and cooling costs
  • ✓ Dryer vent fire risk removed
What's included

What is included in Furnace and Duct Cleaning

Every job follows the same source-removal scope. What changes is the number of runs and whether the coil needs pulling. Here is what you get on a standard single-furnace Pleasant Grove home, and what we quote separately if your system needs it.

✓

All supply and return runs

We brush and vacuum every connected run from the trunk to the register boot. No skipping the far bedroom or the basement line because it is inconvenient. If a run is inaccessible, we tell you before we start and explain what it would take to reach it.

✓

Blower compartment and wheel

The blower wheel collects a felt-like layer of dust that throws the wheel out of balance. We pull the panel, brush the wheel, and vacuum the housing. A balanced wheel runs quieter and pulls less amperage, which your motor will thank you for.

✓

Evaporator coil face cleaning

We clean the accessible face of the coil with a coil cleaning pump sprayer and approved chemicals. If the coil needs to be pulled for a full clean, that is a separate line item and we will quote it before doing the work. Pulling a coil is not something to surprise a customer with.

✓

Register and vent cover washing

Every cover comes off, gets washed, and goes back on. The boot behind it gets vacuumed too. That visible dust ring on your ceiling vents is a sign the run behind it is loaded, so we treat the cover and the run as one job.

✓

Access sealing with mastic and foil tape

Any hole we cut gets closed with duct board and foil tape, then sealed with duct sealant mastic. We do not leave a gap that will leak conditioned air into your crawlspace. Sealed access points also make the next cleaning faster and cheaper.

✓

Dryer vent check and clear

We inspect the dryer vent run and clear it with a dryer vent auger if it is restricted. Lint blockage is a fire risk, and it is cheap to handle while we are already on site. If the exterior cap is broken or the run needs rerouting, we will note it and quote the repair.

How it works

What to expect during your duct cleaning

01

System inspection

We start with a duct camera inspection system run through the main trunk and two or three branch lines. You see the footage on the monitor. We check the blower compartment, the coil, and the filter cabinet, then write down every access point we need to cut. This walkthrough takes about 20 minutes.

02

Containment setup

We connect a negative air machine and HEPA vacuum to the main trunk and seal every register except the one we are working. That keeps the house under negative pressure so nothing escapes into your living space. Drop cloths go down on carpet and hard floors before any tool comes out of the truck.

03

Source removal

A rotary brush duct cleaning machine and air compressor whip travel each run, scrubbing the duct walls and pushing debris back to the vacuum. We clean supply and return runs, the blower wheel, and the coil face with a coil cleaning pump sprayer and approved coil cleaning chemicals. Stubborn buildup gets a second pass.

04

Sealing and register work

Any access holes we cut get closed with duct board and foil tape, then sealed with duct sealant mastic. We pull every vent cover and register, wash them, and reinstall. If a run has torn flexible duct insulation, we note it and can replace that section on the spot or quote it for a return visit.

05

Verification and walkthrough

We take a final camera pass, check static pressure with blower door test equipment, and show you before-and-after footage. You get a written summary listing what we removed and any recommended follow-up. Payment is due at completion, and the workmanship warranty is one year on the cleaning itself.

Tools & methods

Tools and methods we use

Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.

Rotobrush rotary brush system

Scrubs the duct walls in both directions to break loose the bonded dust layer that a vacuum alone cannot move. It is the workhorse on every residential run.

Abatement Technologies HEPA vacuum

Captures fine particulate down to 0.3 microns so the dust we dislodge does not end up on your furniture. We run it in tandem with the negative air machine.

Negative air machine

Holds the entire duct system under negative pressure during cleaning. This is the single most important piece of equipment for keeping your house clean during the job.

Air compressor whip

Reaches into corners and branch takeoffs where a brush cannot fit. It blasts debris back toward the vacuum without damaging duct board or flexible duct.

Duct camera inspection system

Lets us see inside the trunk and branch runs before and after cleaning. You watch the footage with us, so there is no argument about what was there.

Dryer vent auger and brushes

Clears lint blockage from the full length of the dryer vent run. We verify airflow at the exterior cap before calling the job done.

Coil cleaning pump sprayer

Applies approved coil cleaning chemicals evenly across the evaporator fins without bending them. We rinse and verify drainage before closing the cabinet.

Real results

Before and after.

Dog hair return line in Pleasant Grove West

Before

A three-dog household had a return trunk packed with a felt-like mat of hair and dander. The furnace was short-cycling and the far bedrooms never reached temperature. Static pressure was 0.9 inches of water column, well above the blower's design range.

After

We cleared the return, cleaned the blower wheel, and re-sealed the access panel. Static pressure dropped to 0.62 inches. The furnace stopped short-cycling and the back bedrooms warmed up within one heating cycle.

1974 duct board in Old Town Pleasant Grove

Before

Original duct board with failing seams and visible dust streaking around every register. The homeowner had never had the system cleaned and was getting headaches in the mornings. Camera footage showed a half-inch dust layer along the entire trunk.

After

We cut three access points, cleaned the trunk and all branch runs with lower-RPM brushes, and sealed the access with duct board, foil tape, and mastic. The homeowner reported the morning headaches stopped within a week.

Clogged dryer vent in Lindon rental

Before

A rental property dryer was taking two full cycles to dry a load, and the exterior vent cap was barely moving air. The vent run had years of lint packed against a crushed section of flex duct behind the dryer.

After

We cleared the full run with a dryer vent auger and rotary brush, replaced the crushed flex section, and verified airflow at the cap. Dry time dropped from two cycles to one, and the fire risk from lint blockage was eliminated.

Problems we solve

Problems Furnace and Duct Cleaning Pleasant Grove UT solves

Most calls we get start with one of these four complaints. Each one traces back to something inside the ductwork, and each one has a fix that does not involve guessing.

Ask a pro →
01

Black streaks around every ceiling register

We pull the cover, vacuum the boot, brush the run back to the trunk, and seal the boot edges with mastic. The streaks stop coming back because the source is gone, not just wiped away.

↗
02

Musty smell when the furnace kicks on

We camera-inspect the suspect runs, HEPA-vacuum the affected sections, and treat the coil with approved coil cleaning chemicals. If the growth is extensive, we bring in IICRC-certified remediation and document it with photos.

↗
03

Dryer takes two cycles to dry a load

We run a dryer vent auger and rotary brush the full length of the vent to the exterior cap, then verify airflow. Most restricted vents clear in under 30 minutes, and the dryer goes back to one cycle.

↗
04

Furnace short-cycles and rooms never get warm

We clear the return runs, clean the blower wheel, and check static pressure with blower door test equipment. Restoring airflow usually ends the short-cycling without touching the furnace itself.

↗
Proof you can check

Licensed, certified, and reviewed

✓
NADCA Air Systems Cleaning Specialist (ASCS)National Air Duct Cleaners Association
✓
NADCA Certified Ventilation Inspector (CVI)National Air Duct Cleaners Association
✓
EPA Lead-Safe CertificationU.S. Environmental Protection Agency
✓
Utah DOPL Contractor LicenseUtah Division of Occupational and Professional Licensing
✓
IICRC CertificationInstitute of Inspection, Cleaning and Restoration Certification
Good questions

Frequently Asked Questions

(855) 927-7517 →

Most single-family homes in Pleasant Grove run $249 to $550 in 2026, depending on the number of registers and whether the coil needs pulling. Homes over 3,000 square feet or with two furnaces land in the $550 to $850 range. Commercial buildings and multi-unit properties are quoted per system after a walkthrough. You get the number in writing before we start.

Yes. Every full-system cleaning includes the blower compartment and blower wheel. We pull the access panel, brush the wheel, and vacuum the housing because that is where a lot of the fine dust collects. If the blower motor itself is failing, we will tell you and quote a replacement separately rather than clean around a bad part.

Every three to five years for a typical Pleasant Grove home with no pets and no allergies. If you have two or more pets, a family member with asthma, or you have done a remodel in the last two years, move that to every two years. Homes near the Grove Creek and Battle Creek corridors see more spring pollen, so those systems tend to need it on the shorter end.

Look for NADCA ASCS certification, a Utah DOPL license, and a company that shows you camera footage before and after. We meet all three. Hearthline Home has been cleaning systems in Pleasant Grove since 2022, and we will walk you through the before-and-after video on the spot so you can judge the work yourself.

Ready when you are

Book Furnace and Duct Cleaning Pleasant Grove UT this week

Call (855) 927-7517 and we will give you a flat price over the phone, then put you on the schedule. Same-day slots are usually open before noon. NADCA-certified technicians, Utah DOPL licensed, and camera footage on every job.

Book Your Cleaning (855) 927-7517 →
Request an appointment

Reach our Pleasant Grove duct crew

Call (855) 927-7517 and a real person answers, not a call center two states away. We book most Pleasant Grove jobs within 24 hours and keep same-day slots open for dryer vent and emergency calls. If you prefer email, send your address and what you are seeing and we will reply with a flat quote.

Request received — our team will be in touch shortly.
Tap to call(855) 927-7517